Cole-Parmer (formerly Techne Tempette® and Tempunit®) thermostatic controllers are
“Clip on” temperature controllers with mounting clamp suitable for vessels with wall thickness up to 25mm. When the controller is to be used with Techne bath tanks the clamp is unnecessary as a bridge plate is provided. All models incorporate a splash-proof case, coiled immersion heater and pressure circulating pump (except IC300-20HDC). In addition they are fitted with an adjustable overtemperature cut-out and conform to international standards for radio frequency interference. All models have a low liquid level cut-out. IC300-models have a built-in RS232 interface which allows them to communicate with the users’ personal computer if required using Thermsoft PC control freeware available from the Cole-Parmer website.
Techne thermoregulators are designed and manufactured under BS-EN ISO 9001. They conform with all important international RF interference and electrical safety regulations, including the EMC and Low Voltage Directives, and carry the CE-mark.
Model IC-300-20HDC features:
- High precision, digital controller with wide temperature range and fine temperature adjustment
- PID controller with bright, LED readout
- Built-in circulating pressure pump with external connections (suction not available)
- Adjustable overtemperature cut-out
- Fitted with bi-directional RS232 interface for programming by a personal computer
- Low liquid protection by float switch
General specifications:
| Model |
IC-300-10DDC |
IC300-20DDC | IC300-20HDC | |
| Temperature range* | °C | -40 to 120 | -40 to 200 | -40 to 250 |
| Temperature selection | Digital | Digital | Digital | |
| Stability using water at 40°C | ±°C | 0.01 | 0.005 | 0.005 |
| Control method | PID | PID | PID | |
| Setting resolution | °C | 0.1 | 0.1 | 0.1 |
| Display | 4 digit LED | 4 digit LED | 4 digit LED | |
| Display resolution | °C | 0.1 | 0.1 | 0.1 |
| Temperature sensor | PRT | PRT | PRT | |
| Heater power, 220-240V | kW | 1.0 | 1.8 | 1.8 |
| Pump (water) maximum pressure maximum flow | mbar l/min. | 145 10 | 145 10 | - - |
| Overall W x D x H excluding clamp | mm | 237 x 124 x 260 | 237 x 124 x 260 | 237 x 124 x 260 |
| Extension below base | mm | 145 | 145 | 145 |
*A lid or layer of polypropylene spheres must be used when operating between 60°C and 100°C, and is recommended for use below room temperature. Above 100°C, a lid must always be used. Accessory cooling is required for operation near or below ambient temperature.
Supplied with both UK and European Schuko plugged mains supply leads. For 230V 50/60Hz single phase supplies.